Amplifier connection
•
The GZRA MICRO ONE comes with a power and signal connector cable. For a reliable connection we
strongly recommend to use the delivered
spade connections or solder the joints.
•
Make sure input connectors are making good contact with input jacks of the amplifier to avoid shortage or
interruption
•
Never use any other connector instead of the original Ground Zero connector. In case of a defective
connector cable, please contact the Ground Zero service.
Turning on the amplifier
The amplifier automatically turns on a few seconds after you turn on your radio.
Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools
(At about 80° / 176° F).
Adjusting the audio level
1.
LEVEL (Min/Max): Turn fully counter- clockwise to MIN position
2.
Turn the auto sound system's volume control to about two-third of its full range.
3.
Adjust LEVEL to a comfortable listening level.
WARNING !
High powered audio systems in a vehicle are capable of generating "Live Concert" levels of sound pressure. Continued
exposure to excessively high volume sound levels may cause hearing loss or damage. Also, operation of a motor
vehicle while listening to audio equipment at high volume levels may impair your ability to hear external sounds such
as; horns, warning signals, or emergency vehicles, thus constituting to a potential traffic hazard. In the interest of safety,
Consumer Electronics recommends listening at lower volume levels while driving.
Summary of Contents for RADIOACTIVE Series
Page 6: ...RCA low level wiring ...
Page 7: ...High level wiring ...
