GZ BASS KIT 12.300X
Connections and controls
1
Speaker terminal
To connect the speaker wire (of the subwoofer)
2
Power terminal
GND
Ground connection
REM
Remote connection (not necessary when high-level input is used)
BATT
+12 Volt connection
3
Fuse
Replace a defective fuse by a fuse with identical quality and value (30A)
4
High-level input
To connect your head unit (if not equipped with a low-level RCA output)
Connect this input to the speaker outputs of your head unit. The amplifier automatically
turns on (Auto On). The remote needs not to be connected
IMPORTANT!
Do not use the high-level input and the RCA input simultaneously. This may lead to
serious damage of the amplifier. Use either the RCA or the high-level input, only
5
RCA input
To connect the low-level input signal (RCA)
IMPORTANT!
Do not use the high-level input and the RCA input simultaneously. This may lead to
serious damage of the amplifier. Use either the RCA or the high-level input, only
6
RCA output
To connect an additional amplifier (RCA)
7
Gain (level) control
To adjust the input sensitivity
8
Mode switch
To select the crossover mode
LPF
Low frequencies (below selected crossover point) will be reproduced
FULL
Full range reproduction
9
Low pass control
To set the crossover frequency. Set the filter switch to the
LOW
position. Adjust the
variable LPF frequency to the desired frequency using the controller
10
Bass Boost control
To adjust the low bass increase (Bass Boost) at 45 Hz (0 – 6 dB)
11
Status indication
GREEN
Amplifier is in operation mode
RED
Amplifier is in protection mode
12
Remote control
connector
To connect the separately available remote control GZTA Bassremote
