3d.
Use caution (isn’t that better than carefully
again?) as you guide the PCB connecting wire and
plug back on through the access way (or “hole”)
and replug (is that a word?) it back into the mating
socket.
3e.
Place the top portion of the chassis over them
motor assembly, making sure not to make contact
with the motor, and replace screws to secure the
top of the head/shell to the mounting platform and
mic chassis.
3f.
Replace the bottom portion of the shell to the
chassis, again, “carefully” noting the orientation of
the graphics and impedance switch which is a tight fit so gently nudge it into
place and replace the last two screws to hold it all together.
That’s All!
Now let your girlfriend finish tracking that Joplin cover. But this
time use a GT Pop Filter!
VELO-8 Specifications
Microphone Type ..........................Velocity (Ribbon)
Operating Principle........................Electro-dynamic pressure gradient
Polar Pattern..................................Bi-directional (Fig-8)
Generating Element ......................2.5 micron corrugated aluminum ribbon
Ribbon Dimension ........................0.10” x 2.10” (2.50mm x 53.14mm)
Magnetics......................................Custom-Formed Rare Earth Neodymium
Frequency Response......................20Hz - 16kHz ±3db
Sensitivity......................................-50dBV Re. 1V/Pa
Selectable Output Impedance ......Low: 75
Ω
, High: 300
Ω
Recommended Load Impedance....Low: 300-600
Ω
, High: 1200-2400
Ω
High Pass Filter..............................A p p r x . 50Hz in re c ’d low impedance window
Maximum SPL ................................138dB @ 0.5% THD
Output Connector..........................XLR
Polarity ..........................................Pin 2 hot for positive pressure
( f ront of mic)
Dimensions ....................................8 - 1 / 4 ” long
( 2 0 . 5 c m )
, 1 - 7 / 8 ”
( 4 . 7 c m )
m a x . d i a .
Weight............................................1.3 lbs. (590g), mic only
GROOVE TUBES
12
