19
4. Power Tool Use and Care
a.
Do not force the power tool. Use the correct power tool for your application. The correct pow-
er tool will do the job better and safer at the rate for which it was designed.
b.
Do not use the power tool if the switch does not turn it on and off . Any power tool that cannot
be controlled with the switch is dangerous and must be repaired.
c.
Disconnect the plug from the power source and/or the battery pack from the power tool be-
fore making any adjustments, changing accessories, or storing power tools. Such preventive
safety measures reduce the risk of starting the power tool accidentally.
d.
Store idle power tools out of the reach of children. Do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
e.
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may aff ect the power tool’s operation. If damaged, have the
power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g.
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations diff erent from those intended could result in a hazardous situation.
5. Service
a.
Have your power tool serviced by a qualifi ed repair person using only identical original replace-
ment parts. This will ensure that the safety of the power tool is maintained.
Angle Grinder-Specifi c Safety Warnings
Safety warnings common for grinding, sanding, wire brushing, polishing or abrasive cutting-off
operations:
This power tool is intended to function as a grinder, sander, wire brush or cut-off tool.
Read all safety warnings, instructions, illustrations and specifi cations provided with this
power tool.
Failure to follow all instructions listed below may result in electric shock, fi re and/
or serious injury.
This power tool is not recommended for polishing.
Operations for which the power tool
was not designed may create a hazard and cause personal injury.
The rated speed of the accessory must be at least equal to the maximum speed marked
on the power tool.
Accessories running faster than their rated speed can break and fl y apart.
The outside diameter and the thickness of your accessory must be within the capacity
rating of your power tool.
Incorrectly sized accessories cannot be adequately guarded or
controlled.
The arbor size of wheels, fl anges, backing pads or any other accessory must properly fi t
the spindle of the power tool.
Accessories with arbor holes that do not match the mounting
hardware of the power tool will run out of balance, vibrate excessively and may cause loss of
control.
Do not use a damaged accessory in all cases. Before each use, inspect the accessory such
as abrasive wheels for chips and cracks, backing pads for cracks, tears or excess wear,
wire brushes for loose or cracked wires.
If power tool or accessory is dropped, inspect for damage or install an undamaged ac-
cessory. After inspecting and installing an accessory, position yourself and bystanders
away from the plane of the rotating accessory and run the power tool at maximum
no-load speed for one minute.
Damaged accessories will normally break apart during this
test time.
Wear personal protective equipment. Depending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves
Szlifierki_katowe_bateryjne_Full_v04_HR.indd 19
Szlifierki_katowe_bateryjne_Full_v04_HR.indd 19
2016-10-19 04:07:25
2016-10-19 04:07:25
