Grohe F-DIGITAL DELUXE 36 371, Installation Instructions Manual

Page: 35 / 65

DIE
SMC-120 or TC-125
Auxilary Outside
Control
Steam Outlet Pipe
- Use a minimum of a ¾" Copper or Brass pipe.
NOTE:
The SM Series steam generators will also work with the following controls: TC-110, TC-135, DSC-425, and
DSP .
CAUTION:
Do NOT install a shutoff valve on the steam outlet pipe. Do NOT create traps or valleys in this line which
would prevent the flow of steam. The steam outlet pipe should be pitched toward the Steam Generator (preferred),
allowing condensation to run back into the Steam Generator or toward the steamhead. If the steam pipe exceeds ten
feet, use an appropriate pipe insulation rated for a minimum of 212°F.
START
STOP
®
TEMPERATURE
START
STOP
IMPORTANT:
INSTALL WITH ARROWS POINTING UP
WARNING: Unit must be installed
INDOORS, in a DRY, NON-FREEZING
location and with arrows pointing up.
Service by authrorized personnel only.
NOTE: Read all instructions before installation
CAUTION: To prevent internal damage hold all fittings
securely while making plumbing connections.
NOTE: See Wiring Diagram on reverse side of cover.
CAUTION: Turn off electric before removing cover.
NOTE: This is NOT intended to be used for space
heating purposes.
009-1081
Slope ceiling 2" per foot
Steamhead Installation
Steamhead should be mounted
18" above the finished floor or
6" above the rim of the tub as
far from the bather as possible.
Safety Valve
Connect ¾" pipe to an
indirect waste or as
required by local codes.
Union
Required
Auto Drain Ready
½" Capped Line
The Plumbing Instructions must be given to the homeowner for future use.
⅜ " Shutoff Valve
Keep in open
position during
normal operation.
SMC-150 or TC-150
Control
MUST
be installed
inside the steam room.
Connect to Hot or
Cold water supply
Plumbing Installation Instructions
Figure 4 - Typical Installation Models: SM-5, SM-7 and SM-9
09/12
Pub. No. 279-E
- 3 -