58
③
Line selecting: There are five lines to be selected. Line U (up), Line D (down), Line L (left), Line R
(right) and ALL. The button turns green if selected. You can use remote control to operate.
④
There are four directions to adjust the shape of the cursor, Up, Down, Left and Right.
If Line U (the green one) or Line D (the red one) is selected, the selected line can be moved with these
directions.
If Line L or Line R is selected, the top point of the selected line can be moved to left or right with Direction
Up and Direction Down, and the bottom point of the selected line can be moved to left or right with
Direction Left and Direction Right.
⑤
Lines of cursor. The selected one will be thickened for three times. The two lines in the middle will
not be processed.
6
Touch OK to save the settings and exit. Cancel to exit without saving any settings.
Priority
: The default configuration is shown below.
: Press this button, then the priority value of the selected alarm will be added by 1. The
bigger the value is, the lower the priority will be.
: Press this button, then the priority value of the selected alarm will be reduced by 1. The
smaller the value is, the higher the priority will be.
Alarms with higher priority will be triggered first.
1 is the highest priority, and 8 is the lowest.
If two alarms A and B are triggered at the same time, and A’s priority is higher than B’s, then A will
record first. After A finishes the recording, if B is still being triggered, B will then record. However, if B is
no longer being triggered, it will not record.
If alarm B is triggered while recording, if alarm A, whose priority is higher than B, is triggered then, B
will not stop recording.
