GRN Batten 3-54 v5.4
Fixture placement & hanging
The fixture uses a special yoke/stand for attachments. Special brackets for attaching half-couplers and
pipe clamps are also available. Half-couplers or Pipe clamps should be used for hanging the fixture from
standard truss. The built-in ground support should be weighted for added stability. The yoke clutches
should be loosened (rotate handle counter clockwise) before attempting to rotate the fixture in the
yoke. Rotate the clutch handle clockwise to retighten.
A safety cable should be used for every fixture other than those that use ground support.
NOTE:
The GRN Batten fixtures may be mounted in any orientation as long as the attachment is secure
.
Allow a minimum of 3-inches of clearance from all fixture surfaces to insure adequate airflow.
Maintenance
There is no standard maintenance required for the
GRN
Batten fixture. Even though all hardware is
secured with threadlocker or locking hardware, it is always a good idea to look for any loose or missing
hardware and tighten or replace as needed.
NOTE:
All repairs of electronic or structural issues should be done by qualified personnel.
Page 5
