Model T32719 (Mfd. Since 06/21)
-11-
Site Considerations
Figure 7. Minimum working clearances.
47
1
⁄
2
"
20"
Workbench Load
Refer to the
Machine Data Sheet for the weight
and footprint specifications of your machine.
Some workbenches may require additional rein-
forcement to support the weight of the machine
and workpiece materials.
Consider anticipated workpiece sizes and addi-
tional space needed for auxiliary stands, work
tables, or other machinery when establishing a
location for this machine in the shop. Below is
the minimum amount of space needed for the
machine.
Placement Location
Cleaning Fingers
Although rust preventative was applied only to
the visible surfaces of the clamping fingers (see
Figure 5), some may have worked in between and
underneath them. We recommend you remove all
clamping fingers and thoroughly clean them.
To remove the clamping fingers, move clamping
handles (see
Figure 5) toward back of machine
to raise the clamping leaf, then loosen the cap
screws
and remove the clamping fingers and toe
clamps (see
Figure 6).
Figure 5. Location of clamping handle and
fingers.
Clamping
Handle (1 of 2)
Clamping
Finger (1 of 12)
After all fingers have been cleaned, coat them
liberally with a metal protectant (see
Page 18),
and clean the finger guide on the clamping leaf.
Place the fingers along the guide on the clamp-
ing leaf, align the toe clamps to catch the bottom
of the clamping leaf, and tighten the cap screws
enough so the fingers will not fall off. When done,
make sure fingers are properly aligned (refer to
Aligning Fingers on Page 14).
Figure 6. Clamping finger components.
Cap
Screw
Clamping
Leaf
Finger
Guide
Toe
Clamp
Clamping
Finger
Children or untrained people
may be seriously injured by
this machine. Only install in an
access restricted location.
Summary of Contents for T32719
Page 28: ......
