The Model T32591 13" Spiral Cutterhead is
designed to be used only with the DeWalt
DW735 and DW735X (T22222) Planers. DO
NOT install the T32591 in any other planer
model or make. Doing so could result in
property damage or serious personal injury.
Figure 1. Model T32591 Inventory.
For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
MODEL T32591
13" SPIRAL CUTTERHEAD
FOR DEWALT PLANERS
INSTRUCTIONS
COPYRIGHT © MAY, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(FOR MODELS MFD. SINCE 05/21) #KS21865 PRINTED IN TAIWAN
Introduction
The T32591 13" Spiral Cutterhead is designed
to replace the straight-knife cutterhead on the
DeWalt DW735 and DW735X (T22222) Planers.
The total procedure for changing the cutterhead
and reassembling the planer takes approximately
three hours. Read these instructions thoroughly
before beginning. These instructions make refer-
ence to many procedures detailed in your planer
manual. Always consult your manual for these
procedures. We strongly recommend using the
new replacement bearings included with the
T32591, even if the existing bearings appear to be
in good condition. Call Technical Support at (570)
546-9663 if you need help.
Maximum Width of Cut ................................... 13"
Cutterhead Diameter ..................................... 1
7
⁄
8
"
Number of Cutter Rows ..................................... 3
Total Number of Indexable Cutters .................. 30
Specifications
Description Qty
Open-End Wrenches 6, 24 mm ...................1 Ea.
Deep Well Sockets 32, 40mm .....................1 Ea.
Retaining Ring Pliers (Internal and External) .... 1
Hex Wrench 4mm .............................................. 1
Torx Driver T-30 (Included with DW735/X) ....... 1
Phillips Screwdriver #2 ...................................... 1
Steel Hammer ................................................... 1
Hex Bolt
5
⁄
16
"-18 x 2 ........................................... 1
Heavy Leather Gloves ................................1 Pair
Wood Board (Minimum 12" Length) .................. 1
Scrap Cardboard ............................... As Needed
Recommended Tools
Description Qty
A. Ball Bearing 6202-2NSE ............................ 1
B. Ball Bearing 6204-2NSE ............................ 1
C. Flat Hd Torx Screws T-25 10-32 x ½" ........ 5
D. Indexable Inserts 15 x 15 x 2.5mm ............ 5
E. T-Handle Torx Driver T-25 .......................... 1
F. Helical Pinion Gear 8T ............................... 1
G. Spiral Cutterhead 13" ................................. 1
Inventory
(Figure 1)
V1.05.21
A
B
C
D
E
F
G
