T28172/369/370 Roller Tables (Mfd. 10/17)
-3-
Items Needed
Qty
Additional Person .............................................. 1
Tape Measure .................................................... 1
Hex Wrench 6mm .............................................. 1
Open-End Wrench 24mm .................................. 1
Open-End Wrench 16mm .................................. 1
To install roller table and adjust height:
1. Measure table height of machine that will be
used with roller table assembly.
2. With help from an assistant, place roller table
assembly upside-down on clean, level sur-
face (see
Figure 6).
Installation & Height Adjustment
5. With help from an assistant, turn roller table
assembly rightside-up and position it next to
machine work table.
6. Adjust feet up/down as necessary to set
entire length of roller table even with machine
work table, then tighten hex nuts on feet to
secure in position (see
Figure 8).
Roller table height adjusts from 24" to 40" with
adjustable legs and feet. The roller table must be
set to the same height as the machine work table.
The roller table should also be secured direct-
ly to the machine (using the optional T28378
Mounting Plate) to prevent it from shifting over
time. Depending on your setup and the type of
machine being used, a shifted roller table could
result in loss of cutting accuracy or kickback
injuries.
4. At each leg, loosen (4) cap screws securing
inner leg in sleeve, adjust leg in/out so height
of foot-to-ground matches measured height
of machine table, then secure cap screws
(see
Figure 7).
Figure 6. Turn roller table over to adjust leg
height (T28369 shown).
Figure 8. Tighten (4) hex nuts on feet after
adjusting height (T28369 shown).
x 4
3. Loosen hex nuts securing feet and adjust
feet to middle of threaded shaft. This will
allow you to make fine adjustments up or
down later when finalizing roller table height
(see
Figure 7).
7. If required for your setup, secure roller table
assembly to machine (refer to
Securing
Roller Table to Machinery instructions later
in this document).
Figure 7. Adjusting leg height and level (T28369
shown).
Inner
Leg
x 8
x 2
Sleeve