Grizzly T28062, Owner'S Manual

Page: 9 / 16

Model T28062 (Mfd. Since 08/17) -7
-
The following is a list of items shipped
with your tool. Before beginning setup, lay
these items out and inventory them.
If any non-proprietary parts are missing
(e.g. a nut or a washer), we will gladly
replace them; or for the sake of expediency,
replacements can be obtained at your
local hardware store.
If you cannot find an item on this
list, carefully check around/inside
the tool and packaging materials.
Often, these items get lost in pack-
aging materials while unpacking or
they are pre-installed at the factory.
Inventory
Inventory (Figure 2)
A. Mini Rotary Tool .................................1
B. Collets
1
⁄
8
",
3
⁄
32
" ............................ 1 Ea.
C. Screw Mandrels
3
⁄
32
" ...........................2
D. Diamond Bits
3
⁄
32
"
—2mm Round ....................................1
—3mm Flame ....................................1
—1mm Cylindrical ..............................1
—2mm Spear .....................................1
E. Steel Burrs
3
⁄
32
":
—1.5mm Round .................................1
—2mm Cylindrical ..............................1
F. Abrasive Cones:
—Medium ...........................................5
—Coarse ............................................5
G. AC Adapter ........................................1
H. Case (not shown) ...............................1
To test run tool:
1. Clear all setup tools away from
machine.
2. Remove knurled collet nut and collet.
3. Connect tool to power supply.
4. Turn ON/OFF/Variable-Speed Control
dial ON and adjust to low RPM. Verify
motor operation.
5. Make sure tool runs smoothly and with-
out unusual problems or noises.
6. Turn ON/OFF/Variable-Speed Control
dial OFF.
Test Run
C
D
F
B
A
G
E
Figure 2. Inventory.