t21347 2" nailer Kit
-8
-
operations
loading
When replacing nails in your Model t21347,
follow these guidelines:
gauge: 18
length:
5
⁄
8
"–2"
Capacity: 100
to load your nailer:
1.
disConnECt nAilEr FroM thE
Air supply!
2.
sliding magazine pusher back, as
shown in
figure 3,
to lock the catch
lever in place.
3.
insert a strip of nails, pointed-end
down, into the magazine as shown in
figure 4
.
operating
if you have not read the safety instruc-
tions in this manual, do not operate the
nailer.
Before you operate your nailer, place five
to six drops of the included oil into the
quick connect fitting where the nailer con-
nects to the air supply.
to operate your nailer:
1.
Connect the air supply to the quick con-
nect fitting.
2.
to test for proper nail penetration, hold
the nailer perpendicular to the surface
of a piece of clean scrap wood that is
thick enough for the length of nails you
have loaded.
4.
slide the nails all the way down to the
nose of the nailer.
5.
push the magazine pusher all the way
in until the catch lever locks.
figure 4.
loading nails into magazine.
figure 3.
sliding magazine pusher back
and locking catch lever in place.
Catch
lever
