-2-
Model T1251 (Mfd. Since 11/17)
Assembly
1. Lay workbench top upside-down on a
protected surface, such as cardboard or a
blanket.
Note: Bottom-side of workbench top has
threaded holes.
2. Attach each end frame to workbench top with
(2) M8-1.25 x 55 button head cap screws
and (2) 8mm flat washers (see
Figure 4).
DO NOT fully tighten fasteners yet.
IMPORTANT: Match backside of end
frames with backside of workbench top
(see
Figure 4). Holes for vise mounting are
closer to frontside of end frames.
3. Attach upper back support and upper front
support to workbench top with (2) M8-1.25 x
55 button head cap screws and (2) 8mm flat
washers (see
Figure 5). DO NOT fully tighten
fasteners yet.
IMPORTANT: Match upper back support with
backside of workbench top and upper front
support with frontside of workbench top. Upper
front support has holes for vise mounting.
Figure 3. Inventory: workbench.
J
K
L
M
N
O
P
Q
R
S
T
Description Qty
J. Back Apron ................................................ 1
K. Left Apron ................................................... 1
L. Workbench Top .......................................... 1
M. Right Apron ................................................ 1
N. Front Apron................................................. 1
O. End Frames. ............................................... 2
P. Lower Support ............................................ 1
Q. Upper Back Support ................................... 1
R. Upper Front Support .................................. 1
S. Rubber Feet M10-1.5 x 35 .......................... 4
T. Hardware Bag
— External Corner Braces .......................... 6
—Internal Corner Braces ........................... 6
—Button Hd Cap Screws M8-1.25 x 55 ... 22
— Flat Washers 8mm ................................ 40
— Lock Nuts M8-1.25 ................................ 18
—Tap Screws M4 x 25 ............................. 18
—Open-End Wrench 13/14mm .................. 1
— Hex Wrench 5mm ................................... 1
— Hex Wrench 2.5mm ................................ 1
Figure 5. Upper back support attached to
workbench top.
x 2
Upper Back
Support
Backside of
Workbench Top
Figure 4. End frame attached to workbench top.
Backside of
Workbench Top
Backside of
End Frame
x 2
Holes for
Vise Mounting