-24-
g5771 50" slip roll 16 gauge
review the troubleshooting and procedures in this section to fix or adjust your machine if a problem devel-
ops. if you need replacement parts or you are unsure of your repair skills, then feel free to call our technical
support at (570) 546-9663.
SEctION 6: SERvIcE
troubleshooting
Operations
symptom
possible Cause
possible solution
slip roll creates
cones when trying
to create cylinders.
1. rollers are not parallel.
1. adjust rear roller adjustment knobs as necessary to
be sure the rear roller and upper roller are parallel.
a noticeable crease
is formed in the
workpiece.
1. excessive pressure applied in one spot.
1. reduce the radius and perform the bend in several
passes.
Crank does not turn
upper and lower
rollers.
1. gearbox end of upper roller is not secure.
2. gears are damaged.
1. re-center the bushing and secure the hex bolt and
jam nut (
Step 5
on
Page 20
).
2. Check/replace gears.
slip roll does not
bend material.
1. Machine capacities exceeded.
2. rear roller not engaged.
1. use materials within the capacity of the slip roll.
2. Check/adjust rear roller.
