Grizzly MR 1000, Translation Of The Original Instructions For Use

Page: 98 / 164

GB
98
Trouble Shooting
Problem Possible cause Troubleshooting
Device does not
start
On/Off switch ( 5) set to
“Off” (“0” position)
Set the on/off switch ( 5) to
“On” (position “1”) (see “Switch -
ing on and off”)
Rechargeable battery not in -
serted
Insert rechargeable battery (see
“Replacing the rechargeable bat -
tery”)
Defective motor
Send the device in to the Service
Centre for repair
Grass too long
Pre-mow the lawn area if neces -
sary.
Set higher cutting height.
Engine switches
off
Blockage by foreign body Remove foreign body
Device rotates
incessantly on
the lawn area
Boundary wire ( 6) cut or
damaged
Repair the boundary wire ( 6)
Output not satis-
factory or engine
is difficult to op -
erate
Cutting height too low Set higher cutting height
Blades ( 26) blunt Sharpen or replace blades
Blade area blocked Clean device
Blades ( 26) incorrectly as -
sembled
Install blades correctly
Abnormal
sounds, clatter-
ing or vibrations
Blade bolts ( 27)
loose
Tighten blade bolts
Blades damaged ( 26) Replace blades
Replacement parts/Accessories
Spare parts and accessories can be obtained at
www.grizzly-service.eu
If you do not have internet access, please contact the Service Centre (see “Grizzly
Sercice-Center”).