Grizzly H8253, Instruction Manual

Page: 8 / 16

Model H8253 Air Belt Sander -6
-
OPERATIONS
Read the manual before operation.
Become familiar with this tool, its
safety instructions, and its operation
before beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.
Installing the Sanding Belt
1.
DISCONNECT THE SANDER FROM
THE AIR SUPPLY!
2. Place the sanding belt over the contact
wheel, as shown in
Figure 5
.
3. Compress the contact arm shaft by
pressing the contact wheel towards
the drive wheel. Slide the belt over the
drive wheel until it is centered, then
release pressure (
Figure 6
).
Figure 5.
Preparing the sanding belt.
Contact Wheel
Belt
Figure 6.
Attaching the sanding belt.
Contact Wheel
Belt
Drive Wheel
To avoid accidental starting,
disconnect the sander from the air
supply when it is not in use.
Sanding Belt
Like all tools there is potential danger
when operating this tool. Accidents
are frequently caused by lack of
familiarity or failure to pay attention.
If normal safety precautions are
overlooked or ignored, serious
personal injury may occur.