Grizzly H7945, Instruction Manual

Page: 10 / 28

H7945/H7946/H7995 26° Angle Nailer -8
-
OPERATIONS
Loading
Use nails meeting the specifications listed
for your nailer on
Page 4 of this manual.
To load nails in your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
Figure 4. Lifting the pusher into the lock
notch.
3.
Lift the pusher upward toward the nailer
body until the pusher latches into the
lock notch as shown in
Figure 4 .
4.
With the pusher locked at the rear of
the magazine, insert a strip of nails into
the magazine as shown in
Figure 5 .
Figure 5.
Loading a nail strip into the
magazine.
2. Slide the magazine pusher to the rear
of the magazine as shown in Figure 3 .
Point the nailer away from you and
others when connecting the air supply.
The nailer can cycle and discharge a
nail when the air supply is connected.
Ignoring this warning may result in
serious personal injury.
Figure 3. Sliding the pusher to the rear of
the magazine.
Pusher
Lock Notch
5.
Lift the pusher out of the lock notch and
guide it forward to push the nail strip
to the nose of the nailer.
(Do not let it
snap.)
Pusher
Nail Strip