Model h7668 spray gun w/pressure Cup
-10
-
figure 7. Compressed air inlet location.
6. attach the compressed air line to the
air inlet as shown in
figure 7. how-
ever, wait until you have mixed your
paint material and are ready to spray
to complete this step (see
spraying
on
page 11.
note: Using a
1
⁄
4
" NPT quick discon-
nect set-up on the inlet air line (not
included and not shown), will make
operation and maintenance tasks
easier.
note: For the best results, use a filter
that will extract water and oil contami-
nants and a hose that will be dedi-
cated for spray use only. Do not use
a hose that has been used with an
in-line oiler or other possible contami-
nant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
1. fluid control: Controls the volume of
material that travels through the fluid
tip.
2. pattern control: adjusts the spray
pattern from a round pattern to a wide
fan.
3. atomizing cap : Controls the spray
pattern from vertical to horizontal.
4. trigger : two stage trigger. stage
one only releases compressed air for
blowing off the work piece. stage two
sprays material.
5. pressure control Knob: Controls
the fluid pressure inside the spray
gun.
6. safety valve: releases unsafe pres-
sure build-up from pressure cup.
figure 8. Controls.
controls
safety Valve
Fluid Control
pattern Control
pressure Control Knob
atomizing Cap
trigger
figure 9. pressure cup controls.
air inlet
Summary of Contents for H7668
Page 2: ......
