Grizzly H7507, Owner'S Manual

Page: 14 / 32

-12-
Model h7507 (Mfg. since 3/05)
7. install the adjustable feet in the bottom of the
legs.
8. thread the feet into the legs so the leg/foot
assembly is shorter than the rail height.
9. use (4)
1
⁄
4
"-20 x
3
⁄
4
" flat head screws, (2)
1
⁄
4
"
flat washers, and (2)
1
⁄
4
" hex nuts to secure
the legs to the fence rails, as shown in
figure
9.
Note: If your rails do not have mounting holes
to accomodate the router table legs, you may
need to drill holes in the end of the rails to
allow the legs to be fastened, as shown in
Figure 9 .
10. adjust the feet to the ground, then tighten the
hex nut on the foot against the leg to lock the
foot height in place.
11. replace the front rail tube on the rail. figure
10 shows an example of the Model h7507
installed on a saw.
&
¿
)
"'%
=ZmCji
&
¿
)
"'%
;aViLVh]Zg
& ¿
)
"'%m ( ¿
)
;aVi=ZVYHXgZl
AZ\
6Y_jhiVWaZ;ddi
GZVgGV^a
8djciZghjc`
& ¿
)
=daZh[dg
Bdjci^c\AZ\h
figure 9. one of two legs secured to rail for
supporting router table.
IVeZ
figure 7. positioning the tape to shim the router
table down.
— if the outside edge of the router table tilts
up, place strips of masking tape along the
top edge of the saw table to shim the router
table down and even with the saw table
from side to side (see
figure 7).
Note: After reinstalling the router table, remove all
excess masking tape with a razor blade.
( ¿
-
;aVi
LVh]Zg
(
¿
-
AdX`
LVh]Zg
(
¿
-
"&+
=ZmCji
( ¿
-
=daZ
( ¿
-
=daZ
(
¿
-
"&+m&
&
¿
)
=Zm7dai
;gdciGV^a
GZVgGV^a
figure 8. Example of mounting router table to
rails.
Note: If your rails do not have mounting
holes to accommodate the router table, you
may need to drill holes in your fence rails
to allow the router table to be fastened, as
shown in
Figure 8 .
5. remove the fence and front rail tube (if
installed) to give yourself clear access to the
fence rails.
6. use (2)
3
⁄
8
"-16 x 1
1
⁄
4
" hex bolts, (2)
3
⁄
8
" lock
washers, (4)
3
⁄
8
" flat washers, and (2)
3
⁄
8
"-16
hex nuts to secure the router table to the
front/rear fence rails, as shown in
figure 8.
figure 10. Example of Model h7507 installed.