Grizzly H5697, Instruction Manual

Page: 15 / 28

H5697 Cement Mixer -13-
Figure 16. Attaching switch box to the outside
pulley with the existing screws in the switch box.
Figure 17. Securing outside pulley cover to
inside pulley cover.
Figure 18. Installing pinion gear so the
setscrews are directly over the flats on the shaft.
Figure 15. Installing V-belts.
8.
Align the motor and upper pulleys by loosen-
ing the motor pulley set screw, move the
motor pulley in or out until it is aligned with
the upper pulley, then fully tighten the motor
pulley set screw.
9.
Install the V-belts one at a time by first plac-
ing them into the outside motor pulley
groove, then rolling them into the upper pul-
ley grooves, as shown in Figure 15.
10. Pull the motor down to slightly tension the V-
belts and tighten the (4) hex bolts that secure
the motor to the motor mount.
11. Attach the switch box to the outside pulley
cover, as shown in Figure 16, with the (2)
long Phillips head screws, washers and nuts
that are already installed on the switch box.
12. Place the outside pulley cover over the inside
cover and secure it in place with the (4) M5-
.8 x 10 Phillips head screws, as shown in
Figure 17.
13. Insert the pinion gear onto the end of the
upper pulley shaft, so that the (2) M8-1.25 x
8 set screws are directly over the two flats on
the shaft, as shown in Figure 18.
14. When the outside edge of the pinion gear is
flush with the end of the upper pulley shaft,
tighten the set screws.
Shaft Flats
Set Screws