Grizzly H5697, Instruction Manual

Page: 12 / 28

-10- H5697 Cement Mixer
Components and Hardware Needed Qty
Slide Braces ......................................................2
Cross Braces......................................................2
Left Front Leg ....................................................1
Right Front Leg ..................................................1
Right Rear Leg ..................................................1
Left Rear Leg ....................................................1
Corner Braces ....................................................4
Driving End Plate ..............................................1
Yoke Support ....................................................1
Yoke ..................................................................1
Inside Cover ......................................................1
Hex Bolts M8-1.25 x 20 ....................................4
Hex Bolts M8-1.25 x 16 ....................................8
Ext Tooth Washers 8mm ................................12
Hex Nuts M8-1.25 ............................................12
Hex Bolts M10-1.5 x 20 ....................................4
Ext Tooth Washers 10mm ..............................12
Hex Nuts M10-1.5 ............................................12
Carriage Bolts M10-1.5 x 25 ..............................4
Hex Bolts M10-1.5 x 25 ....................................4
Tools Needed
Wrenches/Sockets 13mm ................................2
Wrenches/Sockets 16mm ................................2
To assemble the stand:
Note—Prevent frustration by NOT tightening the
stand bolts until the entire stand is assembled.
1.
Using one of the cross braces, connect the
middle of the left front leg and the middle of
the left rear leg with (2) M8-1.25 x 20 hex
bolts, (2) 8mm exterior tooth washers, and
(2) M8-1.25 hex nuts.
2.
Secure one corner brace on each side of the
assembly with (4) M8-1.25 x 16 hex bolts, (4)
8mm exterior tooth washers, and (4) M8-1.25
hex nuts (see Figure 6).
3. Repeat steps 1 & 2 with the right legs, so
that the assembly mirrors the left stand
assembly shown in Figure 6.
Stand & Yoke
Figure 6.
Left side stand assembly.
Figure 7. Slide brace attached to
stand assembly.
4.
Attach the slide braces to the bottoms of both
stand assemblies with (4) M10-1.5 x 20 hex
bolts, (4) 10mm ext tooth washers, and (4)
M10-1.5 hex nuts (Figure 7).
5.
Using the yoke support, connect the front
legs of the two stand assemblies together
with (4) M10-1.5 x 25 carriage bolts, (4)
10mm ext tooth washers, and (4) M10-1.5
hex nuts (see Figure 8 on the next page).
Cross
Brace
Cross
Brace
Front
Leg
Corner
Braces
Slide
Brace