H3114 Router Table
-3-
9.
USE PROPER EXTENSION CORD
. Make
sure your extension cord is in good condi-
tion. Conductor size must be in accor-
dance with the chart below. The amperage
rating is listed on the motor or tool name-
plate. An undersized cord will cause a drop
in line voltage resulting in loss of power
and overheating. Your extension cord
must also contain a ground wire and plug
pin. Always repair or replace damaged
extension cords.
Minimum Gauge for Extension Cords
10. WEAR PROPER APPAREL.
Do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Non-slip footwear
is recommended. Wear protective hair
covering to contain long hair.
11. ALWAYS USE ANSI-APPROVED SAFE-
TY GLASSES.
Also use face or dust mask
if cutting operation is dusty. Everyday eye-
glasses only have impact resistant lenses,
they are NOT safety glasses.
12. SECURE WORK.
Use clamps or a vise to
hold work when practical. It is safer than
using your hand and frees both hands to
operate tool.
13. NEVER OVERREACH.
Keep proper foot-
ing and balance at all times.
LENGTH
AMP RATING 25ft
50ft
100ft
0-6
18
16
16
7-10
18
16
14
11-12
16
16
14
13-16
14
12
12
17-20
12
12
10
21-30
10
10
No
Safety Instructions For Power Tools
14. MAINTAIN TOOLS WITH CARE.
Keep
tools sharp and clean for best and safest
performance. Follow instructions for lubri-
cating and changing accessories.
15. DISCONNECT TOOLS
before servicing
and changing accessories, such as blades,
bits, cutters, and any other item.
16. REDUCE THE RISK OF UNINTENTIONAL
STARTING.
Make sure switch is in off posi-
tion before plugging in. Also, the magnetic
switch on this machine may start if the
switch gets bumped hard enough.
17. USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recom-
mended accessories. The use of improper
accessories may cause risk of injury.
18. CHECK DAMAGED PARTS.
Before further
use of the tool, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function. Check for
alignment of moving parts, binding of mov-
ing parts, breakage of parts, mounting, and
any other conditions that may affect its
operation. A guard or other part that is dam-
aged must be properly repaired or
replaced.
19. NEVER LEAVE TOOL RUNNING UNAT-
TENDED. TURN POWER OFF.
Do not
leave tool until it comes to a complete stop.
20. NEVER USE UNDER THE INFLUENCE
of
alcohol or drugs, or when tired.
21. IF AT ANY TIME YOU ARE EXPERIENC-
ING DIFFICULTIES
performing the intend-
ed operation, stop using the machine! Then
contact our service department or ask a
qualified expert how the operation should
be performed.
Summary of Contents for H3114
Page 22: ... 20 H3114 Router Table NOTES ...
Page 23: ...H3114 Router Table 21 NOTES ...
Page 27: ......
