-20-
Model h2935/h2936 (Mfg. since 2/12)
Operation
To use the Model H2935/H2936:
1.
place the panels in the upright position
and latch them in place; or fold them down
when sanding larger workpieces that extend
beyond the table.
2.
plug a portable sander into one of the two
outlets. press the workpiece down against
the rubber support grommets as you sand
your workpiece as shown in
Figure 16
.
Note:
Use the power cord hanger (
Figure 16
) to
move long cords out of the way so they do not
interfere with the workpiece.
Two portable electric sanders can be plugged
in and operated simultaneously. However, each
sander must draw 3.5 amps or less. If the 7 amp
maximum draw is exceeded, the circuit breaker
(
Figure 1
) will trip and need to be reset by press-
ing the circuit breaker button.
Make sure the outlet has at least 12" of clear-
ance between obstructions as not to restrict the
air flow.
Figure 16
. typical sanding operation set up.
Cord
hanger
