Grizzly G9984, Owner'S Manual

Page: 22 / 44

-20- G9984/G9985 (Mfd. Since 07/18)
SECTION 7: MAINTENANCE
Lubrication
There are (2) grease fittings shown in Figure 20.
Grease these points after approximately 50 hours
of use.
All other bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. Do not lubricate them.
Regular periodic maintenance of your Model
G9984/G9985 will ensure its optimum perfor-
mance. Make a habit of inspecting your machine
each time you use it. Check for the following con-
ditions and repair or replace when necessary:
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged or worn sanding belt.
5. Any other condition that could hamper the
safe operation of this machine.
General
Tables
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
Wear safety glasses
during the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Tables can be kept rust-free with regular applica-
tions of products like Boeshield
®
T-9. For long
term storage you may want to consider products
like Kleen Bore's Rust Guardit™.
Figure 20. Oscillation grease fittings.
Grease Fittings