Grizzly G3619, Instruction Manual

Page: 20 / 56

Figure 15.
Positive stop.
Table Stop
Always disconnect
power to the machine
when making adjust-
ments. Failure to do this
may result in serious
personal injury.
The positive stop under the table ( see Figure 15 )
allows you to repeatedly square up the table after
adjusting the table tilt. To adjust the positive stop
so the table will return perpendicular (90°) to the
blade after angle cutting
:
1. Make sure the bandsaw is unplugged!
-18- 24" & 27" Resaw Bandsaws
The blade guard is attached to the guide post
above the upper blade guide assembly. For prop-
er setup, the blade should be centered in the
blade guard.
To center the blade guard:
1.
Loosen the hex bolt that secures the blade
guard bracket to the guide post.
2.
Rotate the blade guard bracket in the appro-
priate direction until the blade guard is cen-
tered around the blade as illustrated in
Figure 14
.
3.
Tighten the hex bolt that secures the blade
guard bracket to the guide post.
Blade Guard
Figure 14. Blade centered in blade guard.
Blade
Blade
Guard