Grizzly G0925, Owner'S Manual

Page: 3 / 44

Model G0925 (Mfd. Since 2/20)
-3-
12. Open chuck guard.
13. Use acetone or lacquer thinner to clean
spindle and chuck mating surfaces.
14. Retract chuck jaws completely.
11. Thread (2) M10-1.5 hex nuts from Step 7
onto depth rod, and snap on pointer so it
points at zero (see
Figure 8).
7. Remove (2) M10-1.5 hex nuts, (1) M6-1 hex
nut and (1) 6mm flat washer from depth rod.
8. Pull bottom of chuck guard forward to open
and attach depth rod to guard with M6-1 hex
nut and 6mm flat washer (see
Figure 5).
Figure 5. Attaching depth rod to chuck guard.
Washer
Hex Nut
Depth Rod
10. With chuck guard around quill, tighten Phillips
head screw and hex nut until guard is snug
(see
Figure 7).
9. Close guard and insert depth rod through
mounting hole until guard fits around drill
press quill (see
Figure 6).
Figure 7. Attaching chuck guard to quill.
Quill
Figure 6. Inserting depth rod through mounting
hole.
Mounting Hole
Figure 8. Attaching pointer to depth rod.
Pointer
Hex Nuts