-24-
Model G0900 (Mfd. Since 03/20)
Fence featherboards come pre-installed on fence
faces, allowing clearance with table between 1"
and 5
3
⁄
4
". However, for 0" clearance and up to 2
3
⁄
4
"
clearance, you may remove the featherboard from
the L-bracket it comes installed on.
Featherboards are used to hold the workpiece
flat on the table and snug against the fence.
The G0900 includes two different types of
featherboards: one for use with the table and one
for use with the fence.
Using Featherboards
Note: Position a featherboard for both infeed and
outfeed of workpiece to fully support throughout
cut. Arrow on featherboard indicates workpiece
travel.
Using Table Featherboards
1. To install table featherboards, slide (2) T-slot
nuts into T-slot on table (see
Figure 20).
Tighten knobs at desired position. Adjust
guard and fence to achieve anywhere from
0" to 8" of clearance.
Figure 20. Table featherboard installation.
T-Slot
Featherboard
T-Slot Nuts
Using Fence Featherboards
2. Re-install hardware removed in Step 1 to
featherboard, then slide carriage bolts into
upper slot on fence face (see
Figure 22).
Figure 22. 0" to 2
3
⁄
4
" clearance placement.
Note: Position a featherboard for both infeed and
outfeed of workpiece to fully support throughout
cut. Arrow on featherboard indicates workpiece
travel.
Figure 21. L-bracket and securing hardware.
Knob Bolt
Flat Washer
Carriage Bolt
L-Bracket
Upper Slot
Carriage Bolt
1. Remove hardware securing featherboard to
bracket (see
Figure 21).
To move featherboard to upper slot on fence:
Summary of Contents for G0900
Page 68: ......
