-30-
Model G0842 (Mfd. Since 04/18)
4. Make sure center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
Removing Headstock Center
1. diSConnECt MaChinE FroM poWEr!
2. hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3. insert knockout tool through outbound end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in
figure 35.
figure 35. removing headstock center with
knockout tool.
Knockout tool
installing/Removing
Tailstock Center
the included live center installs into the tailstock
quill with an Mt#2 tapered fit.
items Needed
Qty
leather glove/Clean rag .................................. 1
adjustable Wrench ............................................ 1
2. Make sure mating surfaces of center and
quill are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3. Firmly insert tapered end of center into
tailstock quill, as shown in
figure 36.
4. Make sure center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
5. Secure quill by tightening quill locking nut
against tailstock.
installing Tailstock Center
1. loosen quill locking nut and rotate handwheel
until quill extends about 1", as shown in
figure 36.
figure 36. installing center into tailstock quill.
Quill
handwheel
locking nut
Summary of Contents for G0842
Page 56: ......