Model G0824 (Mfd. Since 12/16)
-77-
Figure 128 shows the gib location on the com-
pound slide. The compound slide gib adjusts in
the same manner and with the same tools as the
cross slide gib. However, in this case, to increase
or decrease tension, the gib adjustment screw
directions are reversed.
2. Adjust cross slide gib screw shown
in
Figure 127 as follows:
— To increase slide tension, loosen rear gib
screw
1
⁄
8
turn, and tighten front gib screw
1
⁄
8
turn.
— To decrease slide tension, loosen front gib
screw
1
⁄
8
turn, and tighten rear gib screw
1
⁄
8
turn.
Figure 127. Cross slide gib components.
Front End of Gib
Front Gib
Screw
Saddle Gib
The saddle is supplied with a carriage lock on the
front right-hand side of the slide (see
Figure 129).
This bolt locks the saddle in place for increased
rigidity when making face cuts. Before making
adjustments to the saddle gib, make sure that this
lock is loose by turning it counterclockwise one
full turn.
IMPORTANT: Do not loosen carriage lock more
than a couple of turns or components inside will
come apart. Re-installing these components is
difficult and time consuming.
Figure 129. Location of carriage lock.
Carriage
Lock
Cross-Slide & Compound-Slide Gibs
Make sure the ways and leadscrew have been
cleaned and re-lubricated before beginning any
adjustments. Refer to
Ball Oiler Lubrication
on
Page 67 for instructions and lubricant
specifications.
Tools Needed
Qty
Standard Screwdriver #2 ................................... 1
Hex Wrench 3mm .............................................. 1
Hex Wrench 5mm .............................................. 1
Hex Wrench 6mm .............................................. 1
To adjust cross slide and compound slide
gibs:
1. DISCONNECT MACHINE FROM POWER!
Figure 128. Compound slide gib components.
Front End of
Gib
Front Gib
Screw
Set Screw
3. Repeat adjustments as necessary until gib
screw drag is acceptable.