Model G0810 (Mfd. Since 10/15)
-37-
SECTION 6: MAINTENANCE
Schedule
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Ongoing
To help minimize your risk of injury and maintain
proper machine operation, if you ever observe
any of the items below shut the machine down
immediately, disconnect it from power, and fix the
problem before continuing operations.
•
Loose mounting bolts or fasteners.
•
Worn, frayed, cracked, or damaged wires.
•
Open belt guard.
•
Any other unsafe condition.
Before Beginning Operations
•
Press the OFF button on the front of the
headstock to prevent spindle startup when
machine is connected to power (see
Page 4).
•
Make sure the X-axis power feed is turned
OFF to prevent unintentional table movement
when machine is connected to power (see
Page 5).
•
Perform lubrication tasks as directed in the
Lubrication section on Page 38.
•
Check table movement in all three axis direc-
tions for loose/tight gibs. Adjust the gibs if
necessary (see
Page 44).
•
Adjust table height, then tighten the Z-axis
table lock (see
Page 4).
Daily, After Operations
•
Disconnect the machine from power.
•
Vacuum/clean all chips and swarf from table,
slides, and base.
•
Wipe down all unpainted or machined sur-
faces with a good quality rust preventative.
Cleaning &
Protecting
Regular cleaning is one of the most important
steps in taking good care of this machine. Each
operator is responsible for cleaning the machine
immediately after using it or at the end of the
day. We recommend that the cleaning routine
be planned into the workflow schedule, so that
adequate time is set aside to do the job right.
Typically, the easiest way to clean swarf from the
ways and table is to use a wet/dry shop vacuum
that is dedicated for this purpose only. The small
chips leftover after vacuuming can be wiped up
with a slightly oiled rag. Avoid using compressed
air to blow off chips, as this may drive them deep-
er into moving surfaces and could cause sharp
chips to fly into your face or hands.
Besides the ways and leadscrews, all other
unpainted and machined surfaces should be
wiped down daily to keep them rust-free and in
top condition. This includes any surface that could
be vulnerable to rust if left unprotected (this espe-
cially includes any parts that may be exposed to
water soluble cutting fluids). Typically with these
parts, a thin film of oil is all that is necessary for
protection.
Keep table rust-free with ISO 68 way oil or other
high-quality metal protectants.
Summary of Contents for G0810
Page 60: ......
