Grizzly G0803Z, Owner'S Manual

Page: 22 / 60

-20-
Model G0803Z (Mfd. Since 12/18)
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
then turn machine
OFF.
The motor should run smoothly and without
problems or unusual noises.
The test run consists of verifying the following:
1) The motor powers up and runs correctly,
and 2) the removable key on the switch works
correctly.
4. Remove key, as shown in Figure 22.
5. Try to start machine with ON/OFF paddle
switch. The machine should not start.
— If the machine does not start, the switch is
working as designed.
— If the machine does start, immediately
stop the machine. The switch is not work-
ing correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
Figure 22. Removing key from ON/OFF paddle
switch.