Model G0796/G0797 (Mfd. Since 1/18)
-61-
5. Remove (3) cap screws from spindle bearing
cover (see
Figure 94).
Figure 94. Spindle bearing cover located on top
of headstock.
Cap Screws
Bearing
Cover
6. Pry off spindle bearing cover (see Figure 95).
Figure 95. Using two flat head screwdrivers to
remove spindle bearing cover.
To replace belts or brake shoes (G0797):
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar (see Page 41).
3. Remove (4) motor mount cap screws, then
remove motor (see
Figure 93).
4. Remove headstock side cover (see
Figure 93) and drive belt.
Figure 93. Location of G0797 motor mount cap
screws and headstock side cover.
Motor Mount
Cap Screws
(3 of 4)
— If replacing drive belt, install new belt using
headstock side cover opening for access
to guide new belt onto motor pulley as you
position motor for re-installation, then re-
install motor with new belt installed.
— If replacing timing belt or brake shoes,
proceed to
Step 5.
Headstock
Side Cover
Tools Needed
Qty
Screwdriver Phillips #2 ...................................... 1
Hex Wrench 5mm .............................................. 1
Wrench 17mm.................................................... 1
External Retaining Ring Pliers .......................... 1
To replace belts or brake shoes:
G0797
Screwdrivers
Summary of Contents for G0796
Page 96: ......
