Model G0720R (Mfg. Since 11/10)
-31-
Figure 37. Right column ball oiler location.
Right Column
Ball Oiler
Figure 35. Headstock ball oiler locations.
Fine Feed
Ball Oilers
Figure 36. Left column ball oiler location.
Left Column
Ball Oiler
Figure 38. Table slide ball oiler locations.
Figure 39. Table and base ball oiler locations.
Front
Ball Oiler
Rear
Ball Oiler
Leadscrew
Ball Oiler
Ball Oilers
This mill has nine ball oilers shown in
Figures
35–39. Make sure to use an oil gun fitted with a
rubber tip that is wide enough to seal the ball oiler
inlet. This seal allows the gun to build hydraulic
pressure in order to flush out contaminants and
deliver fresh oil to components at the end of long
passages.
Do not use oil guns equipped with a sharp steel
lance tip. These narrow tips often seal poorly and
oil is not pumped deep into the system. Steel tips
can also dislodge the sealing ball permanently
exposing the system to contamination.
Items Needed:
Qty
Rubber-Tipped Oil Gun Filled With Way Oil ...... 1
Clean Rags ........................................................ 1
Right Table Ball Oiler (Left Table Ball
Oiler Same Location Other Side)
Summary of Contents for G0720R
Page 56: ......
