-12-
Model g0702 (Mfg. since 8/09)
Mounting
We strongly recommend that you mount your
sander to a workbench to prevent it from moving
during operation. an unexpected movement could
result in an injury or property damage.
there are two machine positioning scenarios that
also must be recognized. if the sander is mounted
directly to a workbench surface, the extended
sanding table will contact the workbench top and
stop at 35° instead of 45°. to prevent this contact,
the sander must be mounted so 6" of the cast
iron table overhangs past the workbench edge,
or the sander can be mounted upon a 2
1
⁄
2
" thick
riser block, which is fastened to the table. in either
of these positions, the table will then be able to
reach a full tilt of 45°.
When you have chosen the location to mount
the sander, the strongest mounting option is
the "through Mount" option (
figure 4
) where
the holes are drilled all the way through the
workbench and hex bolts, washers, and hex nuts
are used to secure the machine.
Machine Base
Workbench
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
figure 4.
Example of a through mount setup.
Machine Base
Workbench
Lag Screw
Flat Washer
figure 5.
Example of a direct mount setup.
another option for mounting is a "direct Mount"
(
figure 5
) where the machine is simply secured
to the workbench with a lag screw.
power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting power
figure 6.
Connecting power.
1.
Turn the machine power switch
OFF
.
2.
Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
