-18-
Model G0678 (Mfd. Since 06/15)
Table Movement
Your mill table has three paths of movement con-
trolled by the corresponding handwheels or crank
(see
Figure 12): 1) Longitudinal (X-axis), 2) cross
feed (Y-axis), and 3) vertical (Z-axis).
Cross Feed
(Y-Axis) or
In & Out
Vertical (Z-Axis) or
Up & Down
Logitudinal (X-Axis)
or Left & Right
Figure 12. The three movement paths of the mill
table.
The graduated dials are marked in increments
of 0.001", with a full revolution moving the table
0.125".
Locks
Use the table, saddle, and knee locks shown in
Figures 13–14 to secure the table in position.
Figure 13. Table locks.
Table Locks
Figure 14. Saddle and knee locks.
Saddle Lock
Knee Lock
Limit Stops
Position the limit stops along the limit stop tracks
to confine the distance the table or saddle can
travel (see
Figures 15–16).
Figure 15. Table limit stops and block.
Longitudinal Limit
Stops
Limit Block
Figure 16. Cross limit stops and block.
Cross Limit Stops
Limit Block
