Grizzly G0632, Owner'S Manual

Page: 35 / 56

G0632 16" x 42" Variable Speed Wood Lathe
-33-
Outboard Turning
Outboard turning is a variation of faceplate turn-
ing and is usually done when the stock diameter
is greater than 12". For the size of this particular
lathe and its minimum turning speed, we recom-
mend a maximum diameter of 17".
Figure 46 depicts the lathe setup at 90° for turn-
ing larger workpieces. When turning in this man-
ner, you must use a free standing tool rest (not
included).
Figure 46.
Headstock set at 90°.
Sanding/Finishing
After the turning operations are complete, the
workpiece can be sanded and finished before
removing it from the lathe (see
Figure 47 ).
Figure 47. Typical sanding operation.
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Keep the lathe tool resting on a tool rest
the ENTIRE time that it is in contact with
workpiece or when preparing to make con-
tact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands into the workpiece.
Failure to heed this warning could result in
serious personal injury.
Wrapping the sandpa-
per completely around
the workpiece could pull
your hands into the mov-
ing workpiece and may
cause serious injury.
Never wrap sandpaper
or finishing materials
completely around the
workpiece.
���������
���������