Grizzly G0632, Owner'S Manual

Page: 26 / 56

-24-
G0632 16" x 42" Variable Speed Wood Lathe
Headstock Faceplate
To mount a workpiece to the faceplate, refer to
Faceplate Turning
on
Page 31
.
The faceplate can be installed only if the head-
stock center has been removed.
To install the headstock faceplate:
1. DISCONNECT THE LATHE FROM THE
POWER SOURCE!
2.
Depress the spindle lock and rotate the spin-
dle by hand until the spindle lock slips into the
locking slot on the spindle (see
Figure 26
).
4.
Using the included 4mm hex wrench, tighten
the three set screws along the inside diam-
eter of the faceplate to secure it to the spindle
(see
Figure 27 ).
To prevent the faceplate and workpiece
separating from the spindle during opera-
tion, the headstock faceplate MUST be firmly
threaded onto the spindle and secured in
place by fully tightening the three faceplate
set screws. If these instructions are not
properly performed, serious personal injury
could occur.
Note:
To remove the headstock faceplate, discon-
nect the lathe from the power source and perform
the steps above in reverse.
Headstock Faceplate
Figure 26.
Depressing the spindle lock.
3.
Maintain pressure on the spindle lock and
thread the faceplate onto the spindle until it is
snug.
Figure 27. Headstock faceplate set screw.
Faceplate Set Screw