Grizzly G0609, Owner'S Manual

Page: 22 / 61

G0609 12" Parallelogram Jointer
-19-
Dust Port
The dust port is installed at the factory, so just
attach it to an adequate dust collection system.
Recommended CFM at Dust Port: .... 615 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must take into account
many variables, including the CFM rating of the
dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system. Explaining this cal-
culation is beyond the scope of this manual. If you
are unsure of your system, consult an expert or
purchase a good dust collection "how-to" book.
DO NOT operate the Model G0609 with-
out an adequate dust collection system.
This machine creates substantial amounts
of wood dust while operating. Failure to use
a dust collection system can result in short
and long-term respiratory illness.
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 32 .
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1.
Connect the machine to the power source.
2.
Twist the STOP button so it pops out.
3.
Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
4.
Make sure all tools and objects used during
set up are cleared away from the machine.
5. Turn the machine ON .
6. Press the STOP button, then restart the
jointer.
7.
Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— Immediately turn the jointer
OFF
if you
suspect any problems, and refer to Page
32
to troubleshoot/fix any problems before
starting the jointer again.
If the source of an unusual noise or vibra-
tion is not readily apparent, contact our
Technical Support at (360) 546-9663.