Grizzly G0603X, Owner'S Manual

Page: 25 / 72

G0603X 25" Extreme Series Planer
-23-
Recommended
Adjustments
For your convenience, the maintenance and
adjustments listed below have been performed
at the factory and no further setup is required to
operate your machine.
However, because of the many variables involved
with shipping, some of these procedures may
need to be repeated to ensure optimum cutting
results. Keep this in mind as you start to use your
new planer.
Step-by-step instructions for these proce-
dures can be found on the referenced pages.
1. Adjust Height of Table Rollers ( Page 28 ).
2. Adjust V-Belts ( Page 30 ).
3. Lubrication ( Page 32 ).
4. Adjust Table Chain Tension ( Page 36 ).
5. Adjust Table Parallelism ( Page 36 ).
6. Adjust Height of Infeed/Outfeed Rollers and
Pressure Bar (
Page 38
).
7.
Adjust Height of Chipbreaker (
Page 40
).
8.
Adjust V-Belt Pulley Alignment (
Page 42
).
9.
Adjust Infeed Roller Tension (
Page 43
).
10.
Adjust Outfeed Roller Tension (
Page 44
).
11.
Adjust Pressure Bar Tension (
Page 44
).
Tighten V-Belts
The final step in the set up process must be done
after approximately 16 hours of operation. During
the first 16 hours, the V-belts will stretch and seat
into the pulley grooves. After 16 hours, the V-
belts must be tensioned or they will slip and burn
out. Refer to
Replace/Adjust V-Belts on Page
30
when you are ready to perform this important
adjustment.
Note: Pulleys and belts run very hot. This is a
normal. Allow them to cool before making adjust-
ments.