G0510Z 3⁄4 HP Shaper
-15-
Safety Guard
The guard protects the operator from inad-
vertent contact with the cutter which could
cause serious personal injury. DO NOT
operate the shaper with the guard removed.
Always replace the guard before operation
if it has been removed for machine service
or maintenance.
Components and Hardware Needed:
Qty
Safety Guard ..................................................... 1
Safety Guard Mounting Post ............................. 1
Safety Guard Attachment Bar ........................... 1
Hex Bolts M8-1.25 x 12 ..................................... 2
Phillips Head Screws M4-.7 x 10 ...................... 2
Hex Nuts M4-.7 ................................................. 2
Flat Washers 8mm ............................................ 2
The Model G0510Z features a clear acrylic safety
guard that is designed to help protect the opera-
tor from flying wood chips and accidental contact
with the cutter/router bit.
Once setup, the safety guard height can be
adjusted by loosening the star knob that secures
the mounting post. Use this safety guard as low
to the cutter as possible without interfering with
your work.
To attach the guard:
1.
Insert the mounting post into the bracket that
is bolted to the back of the shaper table, and
tighten the star knob to lock the mounting
post in place.
2.
Secure the attachment bar to the mounting
post with the hex bolts.
Figure 10.
Safety guard components correctly
assembled on shaper.
3.
Attach the safety guard with the Phillips head
screws and hex nuts. The completed assem-
bly of the safety guard should now look like
Figure 10
.
