-18-
G0462 Wood Lathe (Mfd. Since 11/14)
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To complete a typical operation, the operator
does the following:
1. Examines the workpiece to make sure it is
suitable for turning. No extreme bows, knots,
or cracks should exist.
2. Prepares and trims the workpiece to make it
roughly concentric.
3. Installs the workpiece between centers, or
attaches it to a faceplate or chuck.
4. Adjusts the tool rest to
1
⁄
8
" above the workpiece
centerline, and sets the minimum clearance
between the workpiece and the lip of the tool
rest to
1
⁄
4
".
5. Rotates the workpiece by hand to verify
that the spindle and workpiece rotate freely
throughout the full range of motion.
6. Ties back loose hair and clothing, and puts
on face shield and respirator. Takes all other
required safety precautions.
7. Starts the lathe, adjusts the lathe speed, and
carefully begins the turning operation, keep-
ing the chisel against the tool rest the entire
time it is cutting.
Summary of Contents for G0462
Page 48: ......
