-16-
G0462 Wood Lathe (Mfd. Since 11/14)
4. Install the tool rest lock lever to secure the
tool rest, as shown in
Figure 11.
Figure 11. Installing handle into tool rest.
6. Attach the digital readout to the top of the
head with the pre-installed Phillips head
screws, lock washers, and flat washers, as
shown in
Figure 13.
5. Install the lever into the tailstock so that the
end of it mates with the quill keyway (see
Figure 12).
Note: Make sure the dog-point end of the
lock lever fits into the quill keyway so that
the quill can move in and out of the tailstock
without rotating.
Figure 13. Digital readout installed.
x 2
Figure 12. Quill lock lever.
Quill
Lock Lever
Quill
Keyway
Test Run
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Connect the machine to the power source.
4. Verify that the machine is operating correctly
by turning the machine
ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
Loose hair and clothing
could get caught in machin-
ery and cause serious per-
sonal injury. Keep loose
clothing and long hair away
from moving machinery.
Once assembly is complete, test run your machine
to make sure it runs properly and is ready for
regular operation.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 35.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
Quill Keyway
Summary of Contents for G0462
Page 48: ......
