Model G0458Z (Mfd. Since 7/19)
-23-
Replacing
Sandpaper
5. Loosen cap screw on left clamp and fully
remove sandpaper strip.
6. Use old sandpaper strip as a pattern, if at all
possible. Otherwise, use pattern in
Figure
20, to cut a new piece of sandpaper to the
necessary shape. After cutting the 12
1
⁄
2
"
angled sides, measure 2" along same sides
and cut off ends with a knife.
Figure 20. Sandpaper pattern for drum.
86"
12
1
⁄
2
"
2"
2"
3"
12
1
⁄
2
"
Grit Side Down
7. Insert corner of new sandpaper into left
clamp and tighten cap screw, as shown in
Figure 21.
Note: The angled side of the sandpaper
must be flush with the left drum edge. If the
sandpaper overlaps the edge, you may have
difficulty closing the cover.
The Model G0458Z is designed for 3" wide sand-
paper rolls. Turn to
SECTION 5: ACCESSORIES
on
Page 26 for grit selection and model numbers.
Items Needed
Qty
Flat Head Screwdriver ....................................... 1
Hex Wrench 4mm .............................................. 1
Hex Wrench 5mm .............................................. 1
Carton Cutter or Utility Knife ............................. 1
To change sandpaper:
1. DISCONNECT MACHINE FROM POWER!
2. Open top cover and loosen cap screw on right
spring-loaded clamp, as shown in
Figure 19.
3. Remove sandpaper from clamp. Use a flat
head screwdriver, if necessary, to loosen
clamp to free sandpaper.
4. Rotate drum to carefully remove sandpaper
strip from most of the drum but the end.
Note: Take care not to rip or tear the old
sandpaper, so you can use it as a template
when cutting out the replacement sandpaper
strip. This is easier than using the drawing
shown in
Figure 20.
Figure 19. Example of loosening cap screw on
right spring-loaded clamp (dust hood removed
for clarity).
Access
Hole
Right
Clamp
Tension
Wheel
Figure 21. Securing sandpaper in left clamp.
Left
Clamp
