-18-
Model g0443 (Mfg. since 11/09)
6. place the intake barrel brace in position
and mark the location of the mounting holes
(shown in
figure 14) with a small pencil, nail,
or push pin.
figure 15. using tape on wrench in tight spot.
7. remove the intake barrel you temporar-
ily attached in
Step 4, drill holes where you
marked in
Step 5, and loosely install the wall
mount brace to the wall with the remaining
fasteners from the
Wall Mounting procedure
on
Page 17.
8. use the (12)
5
⁄
16
"-18 x
3
⁄
4
" hex bolts and (12)
5
⁄
16
" flat washers to re-install the intake barrel
to the housing with a barrel gasket in between
(see
figure 13 on Page 19).
Note:
When installing the two bolts above
the intake port, use duct tape on the bottom
of your wrench to hold the bolts in place, as
shown in
Figure 15
, to start the bolts easier.
figure 14. intake barrel brace positioned to
mark the mounting holes.
Mounting
hole
locations
9. attach the cyclone funnel to the intake barrel
with a barrel gasket between them, as shown
in
figure 16, using (12)
5
⁄
16
"-18 x 1" hex bolts,
(24)
5
⁄
16
" flat washers, and (12)
5
⁄
16
"-18 hex
nuts; also secure the wall mounting brace to
the lip of the intake barrel/funnel assembly
with the same hardware.
Note:
At the places where you see 3 holes in
a row, only use the center hole for this step.
The two outside holes are only designed for
use with the optional stand.
figure 16. Cyclone funnel attached to intake
barrel.
Barrel
gasket here
10. tighten the wall mounting brace to the wall.
11. attach the cyclone vacuum tube to the cyclone
funnel with (4)
5
⁄
16
"-18 x
3
⁄
4
" hex bolts and (4)
5
⁄
16
" flat washers, as shown in
figure 17.
figure 17. Cyclone vacuum tube and hose
attachment.
x 12
