Grizzly EXTREME G0513X2, Owner'S Manual

Page: 33 / 100

G0513 Series Bandsaws (Mfd. Since 08/22)
-31-
Figure 43. G0513X2BF control panel.
Power Switch
ON Button
OFF Button
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
G0513X2BF
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, 2) the
safety feature of the OFF button works correctly,
and 3) the foot brake pedal works correctly.
To test run machine:
1. Clear all setup tools away from machine.
2. Press OFF button in.
3. Connect machine to power supply.
4. Insert key into Master Power Key Switch,
then rotate switch to "1" position (see Figure
43). This turns incoming power ON.
5. Twist OFF button clockwise until it springs
out (see Figure 43). This resets switch so
machine can start.
6. Press ON button (see Figure 43) to turn
machine ON. Verify motor starts up and runs
smoothly without any unusual problems or
noises.
7. Press OFF button to turn machine OFF.
8. WITHOUT resetting OFF button, try to start
machine by pressing ON button. Machine
should not start.
— If the machine does not start, the safety
feature of the OFF button is working
correctly.
— If the machine does start, immediately
turn it OFF, disconnect power, and con-
tact customer service for assistance. The
safety feature of the OFF button is NOT
working properly and must be replaced
before further using the machine.
9. Repeat Steps 5–6 to turn machine ON.
10. Allow motor to reach full speed, then step on
foot brake pedal. Blade should stop moving
and motor should turn
OFF.
— If the blade stops moving and the motor
turns
OFF, the foot brake feature is work-
ing correctly. Congratulations! The Test
Run is complete.
— If the blade does not stop moving, or the
motor does not turn OFF, the foot brake
feature is not working correctly. Turn
machine
OFF, disconnect power imme-
diately, and contact customer service for
assistance.