Grizzly EXTREME G0513X2, Owner'S Manual

Page: 26 / 100

-24-
G0513 Series Bandsaws (Mfd. Since 08/22)
16. Attach rail plates to front rail with (3) M6-1 x
20 cap screws, 6mm lock washers, and 6mm
flat washers (see
Figure 28).
Figure 28. Installing front rail onto table.
Knob
Flat
Washer
8mm
Flat Washer 6mm
Lock Washer 6mm
Lock Washer
8mm
Front Rail
Rail Plate
Cap Screw
M6-1 x 20
Cap Screw
M8-1.25 x 20
17. Attach outer two rail plates with round, elon-
gated mounting holes to outer part of table
bottom with (2) M8-1.25 x 20 knobs and 8mm
flat washers.
18. Attach remaining rail plate with round mount-
ing holes using (1) M8-1.25 x 20 cap screw,
8mm lock washer, and 8mm flat washer (see
Figure 28).
19. Thread fence handle into fence, then tighten
hex nut against fence pivot block (see
Figure
29).
Figure 29. Fence handle components.
Hex Nut
Fence
Handle
13. Pull fence handle up and place fence assem-
bly on front rail (see Figures 26–27).
14. Push fence handle down to lock fence assem-
bly in place.
15. Adjust rear rail pad until there is an even
gap between bottom of fence and table, then
tighten rail pad hex nut against fence.
Figure 26. Fence assembly installed on G0513.
Fence
Assembly
Figure 27. Fence assembly installed on
G0513A40 and G0513X2.
Fence
Assembly
Model G0513X2BF