Grizzly 9962ZX, Instruction Manual

Page: 40 / 80

-38- G0445/G0582/G9962Z/9962ZX Wide Belt Sander
NOTICE
Adjust the feed belt tension before adjusting
the feed belt tracking.
Feed Belt Tension Feed Belt Tracking
To adjust the feed belt tracking:
1.
Turn the feed belt
ON
.
2.
If the feed belt is tracking to the
right
side
of the table, turn the right adjustment bolt
(
Figure 38
) clockwise.
3.
If the feed belt is tracking to the
left
side of
the table, turn the left adjustment bolt clock-
wise.
Note:
The edge of the feed belt should just
touch the guide wheels as shown in Figure
39
.
DO NOT sand boards with the guard removed.
Failure to follow this warning could result in
serious personal injury.
Tools Needed: Qty
Wrench or Socket 20mm ....................................1
Phillips Screwdriver #2 ......................................1
To adjust the feed belt tension:
1. DISCONNECT THE SANDER FROM THE
POWER SOURCE!
2.
Find the adjustment ports in the safety guard
( Figure 38 ) at the front end of the fe ed
table.
3.
Turn both left and right adjustment bolts
( Figure 38 ) clockwise equally t o increase
tension.
Figure 38. Feed belt tension adjustment bolts.
Note:
Safety guard removed for clarity.
Safety Guard
Feed Belt
Adjustment
Bolt
Adjustment Bolt
4. When tensioned properly you should not be
able to lift the feed belt off of the table sur-
face or slide it back and forth.
4.
Run the feed belt for 3-5 minutes and recheck
the tracking.
5. If the belt is still tracking correctly, replace
the safety cover removed in the previous
subsection.
Figure 39.
Guide wheels.
Guide Wheel
Tools Needed: Qty
Hex Wrench 6mm ..............................................1
Adjustment Port