FASTENING OF SKI SHOES INTO BINDING FOR DOWNHILL
SKIING
1.
First, it is necessary to flip the flaps on the heel of the binding 90
or 180 degrees backwards so that they do not create an obstacle
for fastening ski boots.
2.
Fasten one and the other ski boot in the front part of binding the
same way as for uphill. Then hit the heels of the ski boots on the
pins of heel parts of the binding so that it locks.
3.
For fastening of ski shoes immediately after the ascent (uphill),
it is only necessary to turn the flaps on the heels of the binding by
90 or 180 degrees and then to hit the heels of the ski boots on the
pins of heel parts of the binding so that it locks.
RELEASE OF SKI SHOES IN BINDING
1.
Release is possible at the toe of the binding by tilting the locking
arms on both skis so that the toes are unlocked and the arms are
deflected to such extent that the inserts are released from the
pins of binding.
2.
If the ski boots have been fastened for downhill, the heels must
still be pulled forward from the heel pins.
PRACTICAL INSTRUCTIONS FOR USE
Prior to each use, a visual inspection of the binding status is required.
In particular:
•
whether the binding is correctly attached to the ski,
•
whether the screws are properly tightened,
•
whether the internal structure of the ski is damaged,
•
whether the ski is damaged in the area of the binding
attachment.
If at least one of the above is not correct, do not use the ski moun-
taineering set until the defect has been repaired by an authorized
service center.
GRIZZLY.SKI bindings differenciate left and right side, so it is neces
-
sary to use skis so that the binding always has a securing arm from
the outside.
If the binding is mounted firmly on the ski, no other ski boot may be
used, only the one for which the binding was mounted.
If the binding heel is on a adjustment plate, it is necessary to check
the distance of the heel when changing the ski boot, whether it is
correctly adjusted by a professionally qualified person.
Before clamping the ski shoes to the binding, make sure that the
skis, ski shoes and the bindings are completely FREE of ice, dirt,
or other foreign bodies that could lead to a reduction in normal
binding functions.
Some binding functions can be handled with a ski pole. Using a ski
pole can cause scratches and / or premature wear of the product
surfaces.
In uphill mode, separation between the ski boot and the binding
only occurs in the event of severe deformations of the material due
to an event, external load or special stress. If this happens, please
stop using the product.
Only the correct size TORX 20 wrench can be used to tighten
the screws.
If in doubt about the perfect functionality of one or more binding
components, do not use the product and seek professional service
for a deeper inspection of the product.
—
7
—
—
6
—
Heel position for downhill
Locked toe of the binding
Released toe of the binding
Locked toe of the binding
