4.0 USE OF THE 5 - Indexable rotogobo module
4.1 Creating a program (use without controller)
Push the MENU key and go through the menu by using the UP and DOWN
keys until the writing "-3 Master/Manual" appears on display; push ENTER to
confirm.
Through UP and DOWN keys, select the program (from 1 to 4) to be created, push ENTER to con-
firm;
Push the UP and DOWN keys: the writings EXECUTION and PROGRAMMING are shown in
sequence; select PROGRAMMING:
Push ENTER: the writing Programming Scene appears on display.
Push again the ENTER key and, through the UP and DOWN keys, select the scene (max 50 per
program) to be created, or to be modified; push ENTER to confirm.
Each time the ENTER key is pushed, the display reads sequentially the value relevant to the chan-
nels:
- 1.
It selects the image (gobo) to be projected and it can acquire values
from 0 to 5; black-out is performed with 0 value and a gobo is selected with
values from 1 to 5.
- 2.
It adjusts the image rotating speed. It can acquire values from
0 to 198, for the indexable positioning, and values from 1 to 9, for the
clock-wise and counter clock-wise rotation.
- 3.
Empty Channel.
- 4.
Empty Channel.
- 5.
Empty Channel.
- 6.
Empty Channel.
- 7.
Pause time: it adjusts the duration of a scene; through the UP and
DOWN keys, select the pre-set pause times (6, 12, 18, 24, 35, 50 seconds;
1, 2, 4, 6, 10, 15, 20, 30 and 40 minutes); push ENTER key to confirm.
Repeat the previous passages for all the scenes that you intend to include in the program.
Push the MENU/ESC key to exit the programming. When the program is operating, all the
scenes, from scene number 1 to the scene in which the ESC key was pushed, are played.
9
Main M
Menu
3.Manual/Master
3.Manual/Master
Program 11
Program 11
Programming
Programming
Scene
Program 11
Scene 0
001
1. IImage w
wheel
001
2Image rrot.speed
001
6. E
Empty
001
7. P
Pause
12 s
sec.
