LED PROJECTOR WITH SENSOR
Please read the instructions carefully to ensure that the
installation is done in the correct manner. This manual should
be properly kept for future reference. Manuals of DVA products
may also be downloaded from the website.
Ensure electricity is switched off before service. Please read
through all following instructions before installing the unit. If
any doubt about correct installation of the unit, please consult
a qualified electrician.
19963
1. The projector must be earthed if possible.
2. Before touching the projector, please switch off the unit
and allow it to cool.
3. In the case of damage to the safety shield, this must
immediately be replaced with tempered glass.
4. Please note the warning mark (label) on the projector.
5. Recommended mounting height of max 3m. (see fig.4)
6. Installation is shown in Figure 4 below
NOTE: If your mains wiring differs in any way, consult a qualified
electrician. Always ensure that the mains supply voltage is
correct. Always replace the fuse with one of an identical rating.
If the external flexible cord of this projector is damaged, it must
be replaced solely by the manufacturer or his service agent or a
similar qualified person to avoid any hazard.
Check that the projector is safely mounted. Ensure that the cable
is not trapped by any sharp objects and that the mains plug
connection is adequately protected against rain or moisture. Your
projector is now ready for use.
IMPORTANT
ELECTRICAL SAFETY
INSTRUCTIONS OF USE
WARNING
Replace any cracked protective shields.
Minimum distance from projector in use: 1m.
1m
DIMENSIONS
19970
FIG 2. FRAME DIMENSIONS
FIG 3. INSTALLATION OF WIRING
19963
19970
FIG 4. MOUNTING
Power lines tripping requirements:
A: neutral= live=earth=15mm
B: neutral=live=earth=6mm (copper clad head)
Blue: neutral
Brown: Live
Green&Yellow:earth
Voltage: 220-240V/50H
